BP-NanoGrout SG

BP-NanoGrout SG is a two component epoxy base, high strength structural adhesive and anchor grout. It is available in paste and pourable grades. When applied it sets and cures rapidly to firmly secure a variety of steel fixings into concrete and masonry substrates. BP-NanoGrout SG offers a very high load-bearing capacity. The system can be installed in percussive and diamond drilled dry or wet holes.

Standards	BS 6319-2, BS 6319-2, ASTM C882
Application Area	BP-NanoGrout SG is used for high strength corrosion resistant nchoring of bolts and bars from 12 – 25mm diameter into concrete, rock, masonry or brickwork where high speed of installation and early application of load is required. Permanent installation of reinforcement starter bars, foundation bolts, base plates, barriers and safety fences, railway tracks, tieback anchors, reinforcement dowelling abutments, ground anchors for towers, cranes, dock sills. BP-NanoGrout SG can also be used as a tructural adhesive to glue metal elements onto concrete or to glue concrete elements together.
Advantages	✓ High early strength ✓ 3 to 4 times stronger than typical concrete ✓ Good adhesion to most of the substrates ✓ Excellent resistance to abrasion and impact ✓ Corrosion resistant ✓ Unaffected by a wide range of acids, alkalis and industrial chemicals ✓ Suitable for dynamic loads • Two grades in paste and pourable variants ✓ Tolerant to damp conditions
Surface Preparation	Surfaces should be dry, clean, free from standing water, grease, curing compounds, mould oils and all loosely adhering particles. Cement laitance should be removed by mechanical means. Rotary percussive drilling will help in providing a rough internal surface which will help in better bonding. Holes can be made using diamond or hammer drilling machines. Depth and diameter of the holes are to determined by the substrate, effective loads and the diameter of the anchor bolts or rebars. The drilled holes need to be cleaned with round brushes and oil-free compressed air directly from a compressor or using special hand pumps. The substrate can be damp, but must be without free standing water. All bars should

BP-NanoGrout SG

Related Products

OUR ADDRESS

OUR E-MAIL

PHONES

WORKING HOURS